C320AMH2 - 

Eaton's?Cutler-Hammer Mechanically Held Lighting Contactors are designed for industrial, commercial and outdoor lighting applications where efficient control is required. The mechanically held operation ensures that the contactor will not switch to OFF during control power failure. It also ensures the removal of coil from the circuit for noise-free operation and the elimination of all coil losses after the contactor is latched. The control module microprocessor validates the control signal before operation, so it will not respond to momentary voltage spikes of noise. The operation command has a built-in .4 sec delay to avoid multiple short-term commands that can cause contact fatigue or failure. Also, the feedback loop prevents the contactor from getting out of sequence with switches, even after power failures. Applications The mechanically held lighting contactor provides effective control in applications such as office buildings, industrial plants, hospitals, stadiums, airports, etc. They are ideal for applications that require quiet, energy-efficient operation. Designed to handle different load types:

Tungsten (Incandescent Filament)

Ballast (Fluorescent and Mercury Arc)

High-Intensity Discharge (HID)

Non-Motor AC Resistive

Single- and Three-Phase Motor Ratings Features

30 Amp Power Pole Rating

Up to 12 Poles Maximum

Low Magnetic Noise Results in Quiet Operation

Low Input VA Permits Long Wire Runs

Come in a Wide Range of Input Voltages and with Coils from 24-277 VAC and 12-24 VDC

Power Poles Latch Easily onto the Base, and Designating Them as NO or NC is a Simple Matter of Left or Right Positioning (Additional Poles, Either NO or NC, May Be Easily Added at Any Time)